Home › Engine / Hybrid System › 2KD-FTV STARTING › STARTER(for DENSO Made)
RM1840EF _51 Engine / Hybrid System _009604 2KD-FTV STARTING _0052423 STARTER(for DENSO Made) A

2KD-FTV STARTING  STARTER(for DENSO Made)  REASSEMBLY  


PROCEDURE

Hide 1.INSTALL STARTER CLUTCH SUB-ASSEMBLY

a.

Apply high-temperature grease to the idler gear, pinion gear, steel ball, return spring, clutch roller and retainer.


b.
P005018

Install the steel ball.


c.

Insert the return spring into the starter clutch hole.


d.

Install the starter clutch, pinion gear, idler gear, retainer and clutch roller to the starter drive housing.


e.

Install the starter drive housing to the magnet starter switch with the 2 screws.

Torque:
9.3 N*m (95 kgf*cm, 82 in.*lbf)


Hide 2.INSTALL STARTER ARMATURE ASSEMBLY

a.

Install the starter armature to the starter yoke.


Hide 3.INSTALL STARTER BRUSH HOLDER ASSEMBLY

a.

Install a new O-ring to the groove of the starter yoke.


b.

Install the starter brush holder to the starter yoke.


c.

Install the 4 starter brushes to the starter brush holder.

i.

Using a screwdriver, pull back the spring.


ii.

Install the brush to the brush holder.

NOTICE:

Check that the positive (+) lead wires are not grounded.




d.

Install the commutator end frame with the 2 screws.

Torque:
3.8 N*m (39 kgf*cm, 34 in.*lbf)


Hide 4.INSTALL STARTER YOKE ASSEMBLY

a.

Install a new O-ring to the groove of the starter yoke.


b.
A115017
2.052,1.646 2.052,1.99 2.052,1.99 2.344,1.99 true 0.917,0.719 0.688,0.49 0.688,0.49 0.521,0.49 true 2.396,1.875 2.635,2.073 0.24,0.198 10 false *1 0.333,0.396 0.531,0.563 0.198,0.167 10 false *2
*1 Protrusion
*2 Groove


Align the protrusion of the starter yoke with the groove of the magnet starter switch.


c.

Install the starter yoke with the 2 through bolts.

Torque:
9.3 N*m (95 kgf*cm, 82 in.*lbf)


d.

Connect the lead wire to terminal C with the nut.

Torque:
5.9 N*m (60 kgf*cm, 52 in.*lbf)