Home › Engine / Hybrid System › 2KD-FTV STARTING › IGNITION SWITCH
RM1840EF _51 Engine / Hybrid System _009604 2KD-FTV STARTING _0052427 IGNITION SWITCH G

2KD-FTV STARTING  IGNITION SWITCH  INSPECTION  


PROCEDURE

Hide 1.INSPECT IGNITION SWITCH ASSEMBLY

A233212
1.677,1.375 2.01,1 2.01,1 2.104,1 true 1.938,1.427 2.396,1.271 2.396,1.271 2.5,1.271 true 1.958,1.563 2.427,1.708 2.427,1.708 2.521,1.708 true 1.24,1.417 0.813,1.271 0.813,1.271 0.719,1.271 true 1.625,1.594 1.396,1.969 1.396,1.969 1.26,1.969 true 1.438,1.583 0.906,1.823 0.906,1.823 0.813,1.823 true 1.49,1.375 1.198,0.99 1.198,0.99 1.104,0.99 true 0.177,0.156 0.458,0.344 0.281,0.188 10 *a 2.135,0.927 2.479,1.083 0.344,0.156 10 ACC 2.552,1.177 2.854,1.344 0.302,0.167 10 IG1 1.01,1.885 1.333,2.042 0.323,0.156 10 IG2 2.573,1.625 2.896,1.781 0.323,0.156 10 AM2 0.365,1.188 0.792,1.344 0.427,0.156 10 AM1 0.51,1.729 0.813,1.875 0.302,0.146 10 ST2 0.833,0.917 1.135,1.063 0.302,0.146 10 ST1
*a Component without harness connected (Ignition Switch)


a.

Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Tester Connection Switch Condition Specified Condition
- LOCK 10 kΩ or higher
2 (ACC) - 4 (AM1) ACC Below 1 Ω
1 (IG1) - 4 (AM1)
2 (ACC) - 4 (AM1)
5 (AM2) - 6 (IG2)
ON Below 1 Ω
1 (IG1) - 4 (AM1)
3 (ST1) - 4 (AM1)
5 (AM2) - 6 (IG2)
5 (AM2) - 7 (ST2)
START Below 1 Ω


If the result is not as specified, replace the ignition switch assembly.