Home › Engine / Hybrid System › 2KD-FTV STARTING › GLOW PLUG(w/ DPF) › from 2012.04
RM1840EF _51 Engine / Hybrid System _009604 2KD-FTV STARTING _0052431 GLOW PLUG(w/ DPF) G

2KD-FTV STARTING  GLOW PLUG(w/ DPF)  ON-VEHICLE INSPECTION  


PROCEDURE

Hide 1.CHECK GLOW PLUG

a.

Remove the No. 1 glow plug connector (See page Engine / Hybrid System>2KD-FTV STARTING>GLOW PLUG(w/ DPF)>REMOVAL).


b.
A241511

Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Tester Connection Condition Specified Condition
Glow plug terminal - Body ground 20°C (68°F) Approximately 1.0 Ω


If the result is not as specified, replace the glow plug.

NOTICE:
·

Be careful not to damage the glow plugs, as this may cause an open circuit or shorten the life of the glow plugs.

·

Do not allow oil or gasoline to contact the glow plug when cleaning it.

·

Clean off any oil on the terminal and Bakelite washer with a dry cloth.

·

Do not apply more than 11 V to the glow plug, as this may cause an open circuit.




c.

Install the No. 1 glow plug connector (See page Engine / Hybrid System>2KD-FTV STARTING>GLOW PLUG(w/ DPF)>INSTALLATION).