1.INSTALL NO. 2 GLOW PLUG CONTROLLER BRACKET
Install the No. 2 glow plug controller bracket to the glow plug controller with the 2 screws.
2.INSTALL NO. 1 GLOW PLUG CONTROLLER BRACKET
Install the No. 1 glow plug controller bracket to the glow plug controller with the 2 screws.
3.INSTALL GLOW PLUG CONTROLLER
Install the glow plug controller with the nut and bolt.
Connect the 4 connectors and clamp.
4.INSTALL BATTERY AND BATTERY TRAY
5.INSTALL BATTERY BRACKET
Install the battery bracket with the bolt and nut.
6.CONNECT CABLE TO BATTERY TERMINAL
When disconnecting the cable, some systems need to be initialized after the cable is reconnected (See page General>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION).