1. PRECAUTION
After turning the ignition switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work (See page General>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION).
2.DISCONNECT CABLE FROM BATTERY TERMINAL
When disconnecting the cable, some systems need to be initialized after the cable is reconnected (See page General>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION).
3.REMOVE BATTERY BRACKET
Remove the bolt, nut and battery bracket.
4.REMOVE BATTERY AND BATTERY TRAY
5.REMOVE GLOW PLUG CONTROLLER
Disconnect the 4 connectors.
Remove the bolt, nut and glow plug controller from the vehicle.
6.REMOVE NO. 1 GLOW PLUG CONTROLLER BRACKET
Remove the 2 screws and No. 1 glow plug controller bracket from the glow plug controller.
7.REMOVE NO. 2 GLOW PLUG CONTROLLER BRACKET
Remove the 2 screws and No. 2 glow plug controller bracket from the glow plug controller.