Home › Engine / Hybrid System › 2TR-FE STARTING › IGNITION SWITCH
RM1840EF _51 Engine / Hybrid System _009605 2TR-FE STARTING _0052435 IGNITION SWITCH G

2TR-FE STARTING  IGNITION SWITCH  INSPECTION  


PROCEDURE

Hide 1.INSPECT IGNITION SWITCH ASSEMBLY

a.
A258154
1.948,0.99 2.281,0.323 2.281,0.323 2.427,0.323 true 2.26,1.083 2.708,0.813 2.708,0.813 2.865,0.813 true 2.271,1.333 2.74,1.469 2.74,1.469 2.823,1.469 true 1.146,1.021 0.573,0.667 0.573,0.667 0.427,0.667 true 1.781,1.365 1.594,1.958 1.594,1.958 1.49,1.958 true 1.448,1.344 0.896,1.906 0.896,1.906 0.74,1.906 true 1.531,0.979 1.063,0.26 1.063,0.26 0.969,0.26 true 0.042,0.021 0.24,0.188 0.198,0.167 10 false *a 2.479,0.229 2.823,0.385 0.344,0.156 10 false ACC 2.917,0.719 3.167,0.875 0.25,0.156 10 false IG1 1.26,1.875 1.531,2.031 0.271,0.156 10 false IG2 2.865,1.375 3.333,1.583 0.469,0.208 10 false AM2 0.135,0.573 0.51,0.781 0.375,0.208 10 false AM1 0.469,1.823 0.823,2.042 0.354,0.219 10 false ST2 0.708,0.177 1.052,0.427 0.344,0.25 10 false ST1
*a Component without harness connected
(Ignition Switch)


Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Tester Connection Switch Condition Specified Condition
All combinations of all terminals LOCK 10 kΩ or higher
2 (ACC) - 4 (AM1) ACC Below 1 Ω
1 (IG1) - 4 (AM1)
2 (ACC) - 4 (AM1)
5 (AM2) - 6 (IG2)
ON Below 1 Ω
1 (IG1) - 4 (AM1)
3 (ST1) - 4 (AM1)
5 (AM2) - 6 (IG2)
5 (AM2) - 7 (ST2)
START Below 1 Ω


If the result is not as specified, replace the ignition switch assembly.