Home › Engine / Hybrid System › 2TR-FE STARTING › STARTER(for 1.7 kW Type) › 2011.10–2012.01
RM1840EF _51 Engine / Hybrid System _009605 2TR-FE STARTING _0052437 STARTER(for 1.7 kW Type) A

2TR-FE STARTING  STARTER(for 1.7 kW Type)  INSTALLATION  


PROCEDURE

Hide 1.INSTALL STARTER ASSEMBLY

a.

Install the starter with the 2 bolts.

Torque:
37 N*m (377 kgf*cm, 27 ft.*lbf)


b.

Install the starter wire to the terminal 30 with the nut.

Torque:
9.8 N*m (100 kgf*cm, 87 in.*lbf)


c.

Connect the terminal cap.


d.

Connect the starter connector.


Hide 3.INSTALL FRONT FENDER SEAL

a.

Install the fender seal with the 5 clips.


Hide 4.CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

NOTICE:

When disconnecting the cable, some systems need to be initialized after the cable is reconnected (See page General>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION).