1.INSTALL STARTER ASSEMBLY
Install the starter with the 2 bolts.
Install the starter wire to the terminal 30 with the nut.
Connect the terminal cap.
Connect the starter connector.
2.INSTALL TRANSMISSION OIL FILLER TUBE SUB-ASSEMBLY (for Automatic Transmission)
3.CONNECT CLUTCH RELEASE CYLINDER ASSEMBLY (for Manual Transmission)
4.INSTALL FRONT FENDER SEAL
Install the fender seal with the 5 clips.
5.CONNECT CABLE TO NEGATIVE BATTERY TERMINAL
When disconnecting the cable, some systems need to be initialized after the cable is reconnected (See page General>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION).