Home › Engine / Hybrid System › 2TR-FBE STARTING › STARTER › 2011.10–2012.01
RM1840EF _51 Engine / Hybrid System _009606 2TR-FBE STARTING _0052439 STARTER A

2TR-FBE STARTING  STARTER  INSTALLATION  


PROCEDURE

Hide 1.INSTALL STARTER ASSEMBLY

a.

Install the starter with the 2 bolts.

Torque:
37 N*m (377 kgf*cm, 27 ft.*lbf)


b.

Install the starter wire to the terminal 30 with the nut.

Torque:
9.8 N*m (100 kgf*cm, 87 in.*lbf)


c.

Connect the terminal cap.


d.

Connect the starter connector.


Hide 2.INSTALL TRANSMISSION OIL FILLER TUBE SUB-ASSEMBLY (for Automatic Transmission)

Hide 3.CONNECT CLUTCH RELEASE CYLINDER ASSEMBLY (for Manual Transmission)

Hide 4.INSTALL FRONT FENDER SEAL

a.

Install the fender seal with the 5 clips.


Hide 5.CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

NOTICE:

When disconnecting the cable, some systems need to be initialized after the cable is reconnected (See page General>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION).