1.INSPECT IGNITION SWITCH ASSEMBLY
| *a | Component without harness connected
(Ignition Switch) |
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Switch Condition | Specified Condition |
|---|---|---|
| All combinations of all terminals | LOCK | 10 kΩ or higher |
| 2 (ACC) - 4 (AM1) | ACC | Below 1 Ω |
| 1 (IG1) - 4 (AM1)
2 (ACC) - 4 (AM1) 5 (AM2) - 6 (IG2) |
ON | Below 1 Ω |
| 1 (IG1) - 4 (AM1)
3 (ST1) - 4 (AM1) 5 (AM2) - 6 (IG2) 5 (AM2) - 7 (ST2) |
START | Below 1 Ω |
If the result is not as specified, replace the ignition switch assembly.