Home › Engine / Hybrid System › 1GR-FE STARTING › STARTER › 2012.04–2012.10
RM1840EF _51 Engine / Hybrid System _009607 1GR-FE STARTING _0052443 STARTER A

1GR-FE STARTING  STARTER  INSTALLATION  


PROCEDURE

Hide 1.INSTALL FLYWHEEL HOUSING SIDE COVER

Hide 2.INSTALL STARTER ASSEMBLY

a.

Install the starter with the 2 bolts.

Torque:
58 N*m (591 kgf*cm, 43 ft.*lbf)


b.

Connect the wire harness with the bolt.

Torque:
20 N*m (202 kgf*cm, 15 ft.*lbf)


c.

Connect the starter wire with the nut.

Torque:
9.8 N*m (100 kgf*cm, 87 in.*lbf)


d.

Connect the terminal cap.


e.

Connect the starter connector.


Hide 3.INSTALL FRONT FENDER SEAL

a.

Install the seal with the 5 clips.


Hide 4.CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

NOTICE:

When disconnecting the cable, some systems need to be initialized after the cable is reconnected (See page General>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION).