Home › Engine / Hybrid System › 1GR-FE STARTING › STARTER › 2012.04–2012.10
RM1840EF _51 Engine / Hybrid System _009607 1GR-FE STARTING _0052443 STARTER A

1GR-FE STARTING  STARTER  REMOVAL  


PROCEDURE

Hide 1. PRECAUTION

NOTICE:

After turning the ignition switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work (See page General>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION).


Hide 2.DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

NOTICE:

When disconnecting the cable, some systems need to be initialized after the cable is reconnected (See page General>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION).


Hide 3.REMOVE FRONT FENDER SEAL

a.

Remove the 5 clips and seal.


Hide 4.REMOVE STARTER ASSEMBLY

A251403

a.

Disconnect the starter connector.


b.

Disconnect the terminal cap.


c.

Remove the nut and disconnect the starter wire.


d.

Remove the bolt and disconnect the wire harness.


e.
A112759

Remove the 2 bolts and starter.


Hide 5.REMOVE FLYWHEEL HOUSING SIDE COVER