Home › Engine / Hybrid System › 1GR-FE STARTING › STARTER › from 2012.04
RM1840EF _51 Engine / Hybrid System _009607 1GR-FE STARTING _0052443 STARTER A

1GR-FE STARTING  STARTER  DISASSEMBLY  


PROCEDURE

Hide 1.REMOVE REPAIR SERVICE STARTER KIT

a.
A081590

Remove the nut and disconnect the lead wire from terminal C.


b.
A082688

Remove the 2 screws holding the repair service starter kit to the starter drive housing.


c.

Remove the repair service starter kit.


d.

Remove the return spring and plunger from the starter drive housing.


Hide 2.REMOVE STARTER YOKE ASSEMBLY

a.
A082689

Remove the 2 through bolts and pull out the starter yoke together with the starter commutator end frame.


Hide 3.REMOVE STARTER COMMUTATOR END FRAME ASSEMBLY

a.
A251392

Remove the starter commutator end frame from the starter yoke.


Hide 4.REMOVE STARTER ARMATURE PLATE

a.
A083803

Remove the starter armature plate from the starter yoke.


Hide 5.REMOVE STARTER COMMUTATOR END FRAME COVER

a.
A083801

Using a screwdriver, remove the starter commutator end frame cover.


Hide 6.REMOVE STARTER ARMATURE ASSEMBLY

NOTICE:

Do not drop the starter armature.


a.

Mount the starter commutator end frame in a vise between aluminum plates.

NOTICE:

Do not damage the starter commutator end frame.



b.
A073993

Using snap ring pliers, remove the snap ring and plate washer.

NOTICE:

Do not drop the starter armature.



c.

Remove the starter armature from the starter commutator end frame.


Hide 7.REMOVE PLANETARY GEAR

a.
A082690

Remove the 3 planetary gears from the starter center bearing clutch.


Hide 8.REMOVE STARTER CENTER BEARING CLUTCH SUB-ASSEMBLY

A073990

a.

Remove the starter center bearing clutch and drive lever set pin from the starter drive housing.


b.

Remove the drive lever set pin from the starter center bearing clutch.