CHECK ECM
Disconnect the C23, G38 and G39 ECM connectors.
Measure the voltage and resistance according to the value(s) in the table below.
| Terminal No. (Symbol) | Wiring Color | Terminal Description | Condition | Specified Condition |
|---|---|---|---|---|
| G38-2 (BATT) - C23-7 (E1) | L - BR | Battery | Always | 11 to 14 V |
| G39-9 (IGSW) - C23-7 (E1) | B-O - BR | IG power supply | Ignition switch ON | 11 to 14 V |
| Ignition switch off | Below 1 V | |||
| G38-15 (STP) - C23-7 (E1) | G-W - BR | Stop light switch input signal | Brake pedal released | Below 1 V |
| Brake pedal depressed | 11 to 14 V | |||
| G38-14 (ST1-) - C23-7 (E1) | R-L - BR | Cruise cancel input signal | Ignition switch ON
Brake pedal depressed |
Below 1 V |
| Ignition switch ON
Brake pedal released |
11 to 14 V | |||
| C23-7 (E1) - Body ground | BR - Body ground | Ground | Always | Below 1 Ω |
If the result is not as specified, there may be a malfunction on the wire harness side.
Reconnect the C23, G38 and G39 ECM connectors.
Measure the voltage according to the value(s) in the table below.
| Terminal No. (Symbol) | Wiring Color | Terminal Description | Condition | Specified Condition |
|---|---|---|---|---|
| G39-21 (CCS) - C23-7 (E1) | G-W - BR | Cruise control main switch signal | Ignition switch ON | 11 to 14 V |
| Ignition switch ON
CANCEL switch held on |
6.6 to 10.1 V | |||
| Ignition switch ON
-SET switch held on |
4.5 to 7.1 V | |||
| Ignition switch ON
+RES switch held on |
2.3 to 4.0 V | |||
| Ignition switch ON
Cruise control main switch on |
Below 1 V | |||
| G38-3 (P1) - C23-7 (E1) | L-B - BR | Cruise main indicator light input signal | Ignition switch ON
Cruise control main switch on |
Below 1 V |
| G38-3 (P1) - C23-7 (E1) | L-B - BR | Cruise control main switch signal | Ignition switch ON
Cruise control main switch off |
11 to 14 V |
| G39-11 (TC) - C23-7 (E1) | P-B - BR | Terminal TC of DLC3 | Ignition switch ON | 9 to 14 V |
If the result is not as specified, the ECM may be malfunctioning.