Home › Engine / Hybrid System › CRUISE CONTROL › CRUISE CONTROL SYSTEM
RM1840EF _51 Engine / Hybrid System _009608 CRUISE CONTROL _0052446 CRUISE CONTROL SYSTEM U

CRUISE CONTROL  CRUISE CONTROL SYSTEM  DATA LIST / ACTIVE TEST  


DATA LIST


HINT:

Using the intelligent tester to read the Data List allows the values or states of switches, sensors, actuators and other items to be read without removing any parts. This non-intrusive inspection can be very useful because intermittent conditions or signals may be discovered before parts or wiring is disturbed. Reading the Data List information early in troubleshooting is one way to save diagnostic time.


NOTICE:

In the table below, values listed under "Normal Condition" are reference values. Do not depend solely on these reference values when deciding whether a part is faulty or not.


a.

Connect the intelligent tester to the DLC3.


b.

Turn the ignition switch to ON.


c.

Turn the intelligent tester on.


d.

Enter the following menus: Powertrain / Cruise Control / Data List.


e.

According to the display on the intelligent tester, read the Data List.

Powertrain > Cruise Control > Data List
Tester Display Measurement Item Range Normal Condition Diagnostic Note
CCS Vehicle Spd Vehicle speed min.: 0 km/h (0 mph), max.: 255 km/h (158 mph) Actual vehicle speed displayed -
CCS Mem Vehicle Spd Memory vehicle speed min.: 0 km/h (0 mph), max.: 200 km/h (125 mph) Actual vehicle speed stored in memory -
Throttle Opening Angle Throttle opening angle min.: 0%, max.: 100% Actual required throttle opening angle -
Cruise Control Cruise control system active condition ON or OFF ON: Cruise control system activated
OFF: Cruise control system inactivated
-
CCS Main SW M-CPU Cruise control main switch signal (Main CPU) ON or OFF ON: Cruise control main switch (Main CPU) on
OFF: Cruise control main switch (Main CPU) off
-
CCS Ready M-CPU Cruise control system standby condition (Main CPU) ON or OFF ON: Cruise control main switch (Main CPU) on
OFF: Cruise control main switch (Main CPU) off
-
CCS Indicator M-CPU Cruise main indicator signal (Main CPU) ON or OFF ON: Cruise control indicator (Main CPU) on
OFF: Cruise control indicator (Main CPU) off
-
Cancel Switch CANCEL switch signal ON or OFF ON: CANCEL switch on
OFF: CANCEL switch off
-
SET/COAST Switch SET / COAST switch signal ON or OFF ON: -SET switch on
OFF: -SET switch off
-
RES/ACC Switch RES / ACC switch signal ON or OFF ON: +RES switch on
OFF: +RES switch off
-
Stop Light Switch 1 Stop light switch signal ON or OFF ON: Brake pedal depressed
OFF: Brake pedal released
-
Stop Light Switch 2 Stop light switch signal ON or OFF ON: Brake pedal depressed
OFF: Brake pedal released
-
Cruise Operation Status PNP switch signal (D position) ON or OFF ON: Shift lever in D or 3
OFF: Shift lever not in D or 3
-