Home › Engine / Hybrid System › CRUISE CONTROL › CRUISE CONTROL SYSTEM
RM1840EF _51 Engine / Hybrid System _009608 CRUISE CONTROL _0052446 CRUISE CONTROL SYSTEM U

CRUISE CONTROL  CRUISE CONTROL SYSTEM  FAIL-SAFE CHART  


HINT:

If the following conditions are detected while cruise control is in operation, the system clears the stored vehicle speed in the ECM and cancels cruise control.


Vehicle Condition Auto Cancel Condition Fail-safe Deactivation Condition
Cruise control indicator light blinks
·

There is an open or short in the stop light switch circuit

·

There is a problem with the vehicle speed signal


Turn the cruise control main switch on again
·

There is a problem with the input circuit of the stop light switch circuit

·

There is a problem with the cancel circuit

·

There is a problem with the ECD system


·

Turn the cruise control main switch on again

·

Turn the ignition switch off and then on again


Cruise control indicator light remains on
(Cruise control is canceled)
Under the following conditions, the stored vehicle speed is maintained:
·

The vehicle speed is less than the low speed limit (approximately 40 km/h (25 mph)) while running with the cruise control on

·

The VSC system is operated


Push the cruise control main switch to RES / ACC
·

The vehicle speed is less than the stored speed by approximately 16 km/h (10 mph) or more


Push the cruise control main switch to SET / COAST
Cruise control indicator light goes off There is a problem with the fuel injection system Fuel injection system returns to normal