Home › Engine / Hybrid System › CRUISE CONTROL › CRUISE CONTROL MAIN SWITCH
RM1840EF _51 Engine / Hybrid System _009608 CRUISE CONTROL _0052447 CRUISE CONTROL MAIN SWITCH G

CRUISE CONTROL  CRUISE CONTROL MAIN SWITCH  INSPECTION  


PROCEDURE

Hide 1.INSPECT CRUISE CONTROL MAIN SWITCH

a.

Measure the resistance according to the value(s) in the table below.

B215369
0.917,2.427 0.646,2.813 true 1.313,2.427 1.531,2.781 true 0.406,2.865 0.781,3.052 0.375,0.188 10 false CCS 1.479,2.823 1.854,3 0.375,0.177 10 false ECC 2.573,2.729 3.042,2.917 0.469,0.188 10 false (CCS) 2.573,2.042 3.052,2.229 0.479,0.188 10 false (ECC) 3.865,2.385 4.302,2.594 0.438,0.208 10 false MAIN 4.531,2.385 4.99,2.583 0.458,0.198 10 false +RES 5.292,2.385 5.677,2.573 0.385,0.188 10 false -SET 6,2.385 6.635,2.635 0.635,0.25 10 false CANCEL 0.323,1.813 0.635,2.063 0.313,0.25 10 false *a
*a Component without harness connected
(Cruise Control Main Switch)
- -


Standard Resistance:
Tester Connection Switch Condition Specified Condition
1 (ECC) - 3 (CCS) Neutral 1 MΩ or higher
1 (ECC) - 3 (CCS) +RES 235 to 245 Ω
1 (ECC) - 3 (CCS) -SET 617 to 643 Ω
1 (ECC) - 3 (CCS) CANCEL 1509 to 1571 Ω
1 (ECC) - 3 (CCS) Main switch off 1 MΩ or higher
1 (ECC) - 3 (CCS) Main switch on Below 2.5 Ω


If the result is not as specified, replace the cruise control main switch.