1. PRECAUTION
After turning the ignition switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work (See page General>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION).
2.DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.
When disconnecting the cable, some systems need to be initialized after the cable is reconnected (See page General>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION).
3.REMOVE LOWER NO. 3 STEERING WHEEL COVER
4.REMOVE LOWER NO. 2 STEERING WHEEL COVER
5.REMOVE STEERING PAD
6.REMOVE CRUISE CONTROL MAIN SWITCH
Disconnect the connector.
Remove the 2 screws.
Remove the switch as shown in the illustration.