Home › Drivetrain › A340F AUTOMATIC TRANSMISSION / TRANSAXLE › OIL PUMP
RM1840EF _52 Drivetrain _009609 A340F AUTOMATIC TRANSMISSION / TRANSAXLE _0052448 OIL PUMP A

A340F AUTOMATIC TRANSMISSION / TRANSAXLE  OIL PUMP  REASSEMBLY  


PROCEDURE

Hide 1.INSTALL FRONT OIL PUMP OIL SEAL

AT05154
1.146,1.25 0.583,0.781 false 0.25,0.677 0.688,0.875 0.438,0.198 10 false SST

a.

Using SST and a hammer, tap in a new oil seal.

SST
09350-30020  (09351-32140)

HINT:

The oil seal end should be flush with the outer edge of the pump body.



b.

Coat the oil seal lip with MP grease.


Hide 2.FIX FRONT OIL PUMP BODY

a.

Place the oil pump body on the torque converter clutch.


Hide 3.INSTALL FRONT OIL PUMP DRIVEN GEAR

D025800

a.

Coat the driven gear with ATF.


b.

Install the driven gear to the oil pump body.


Hide 4.INSTALL FRONT OIL PUMP DRIVE GEAR

D025799

a.

Coat the drive gear with ATF.


b.

Install the drive gear to the oil pump body.


Hide 5.INSTALL STATOR SHAFT ASSEMBLY

C283054

a.

Align the stator shaft with each bolt hole.


b.

Install the 13 bolts.

Torque:
10 N*m (100 kgf*cm, 7 ft.*lbf)


Hide 6.INSTALL CLUTCH DRUM OIL SEAL RING

AT08409

a.

Coat the 2 oil seal rings with ATF.


b.

Squeeze the ends of the 2 oil seal rings together with the overlap distance 8.0 mm (0.314 in.) or less, and than install them to the stator shaft groove.

HINT:

After installing the oil seal rings, check that they rotate smoothly.



Hide 8.INSTALL FRONT OIL PUMP BODY O-RING

D025646

a.

Install a new O-ring to the oil pump.