1.INSPECT AUTOMATIC TRANSMISSION FLUID TEMPERATURE SENSOR
| *a | Component without harness connected
(ATF Temperature Sensor) |
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| 1 - 2 | Always | 79 Ω to 156 kΩ |
| 1 - Body ground | Always | 1 MΩ or higher |
| 2 - Body ground | Always | 1 MΩ or higher |
If the resistance is out of the specified range at either of the ATF temperatures shown in the table below, the driveability of the vehicle may decrease.
| ATF Temperature | Specified Condition |
|---|---|
| 20°C (68°F) | 10.3 to 13.9 kΩ |
| 110°C (230°F) | 0.68 to 0.88 kΩ |
If the result is not as specified, replace the ATF temperature sensor.