Home › Drivetrain › A340F AUTOMATIC TRANSMISSION / TRANSAXLE › TRANSMISSION CONTROL CABLE
RM1840EF _52 Drivetrain _009609 A340F AUTOMATIC TRANSMISSION / TRANSAXLE _0052457 TRANSMISSION CONTROL CABLE N

A340F AUTOMATIC TRANSMISSION / TRANSAXLE  TRANSMISSION CONTROL CABLE  ADJUSTMENT  


PROCEDURE

Hide 1.INSPECT SHIFT LEVER POSITION

a.

When moving the shift lever from P to R with the ignition switch ON and the brake pedal depressed, make sure that the shift lever moves smoothly and correctly into position.


b.

Start the engine and make sure that the vehicle moves forward after moving the shift lever from N to D, and moves rearward after shifting to the R.

If the results are not as specified, inspect the park/neutral position switch and check the shift lever.


Hide 2.ADJUST SHIFT LEVER POSITION

C283118

a.

Move the shift lever to N.


b.

Remove the nut and disconnect the control cable.


c.
C236140
1.365,0.094 1.521,0.271 0.156,0.177 10 N 1.75,0.417 1.906,0.594 0.156,0.177 10 R 2.271,0.313 2.427,0.49 0.156,0.177 10 P

Turn the control shaft lever clockwise until it stops, and then turn it counterclockwise 2 notches to set it to the N position.


d.

While holding the control shaft lever slightly toward the R position side, connect the cable with the nut.

Torque:
16 N*m (163 kgf*cm, 12 ft.*lbf)