Home › Drivetrain › A343E AUTOMATIC TRANSMISSION / TRANSAXLE › AUTOMATIC TRANSMISSION SYSTEM(for 2TR-FBE)
RM1840EF _52 Drivetrain _009610 A343E AUTOMATIC TRANSMISSION / TRANSAXLE _0052463 AUTOMATIC TRANSMISSION SYSTEM(for 2TR-FBE) D

A343E AUTOMATIC TRANSMISSION / TRANSAXLE  AUTOMATIC TRANSMISSION SYSTEM(for 2TR-FBE)  HYDRAULIC TEST  


PERFORM HYDRAULIC TEST


a.

Measure the line pressure.

CAUTION:

The line pressure test should always be performed with at least 2 people. One person should observe the condition of the wheels and wheel chocks while the other is performing the test.


NOTICE:
·

Perform the test while the ATF (Automatic Transmission Fluid) temperature is between 50 and 80°C (122 and 176°F).

·

Be careful to prevent the hose of SST from interfering with the exhaust pipe.

·

This check must be conducted after checking and adjusting the engine.

·

Perform the test with the A/C off.

·

When conducting the stall test, do not continue for more than 5 seconds.



i.

Warm up the ATF (Automatic Transmission Fluid).


ii.

Turn the ignition switch off.


iii.

Lift the vehicle up.


iv.
C212055
0.583,1.531 0.521,1.802 0.521,1.802 0.438,1.802 false 0.115,1.729 0.438,1.927 0.323,0.198 10 false SST 2.99,0.354 3.313,0.552 0.323,0.198 10 false SST

Remove the test plug from the transmission case and connect SST.

SST
09992-00095  (09992-00231, 09992-00271)


v.

Lower the vehicle.


vi.

Fully apply the parking brake and chock the 4 wheels.


vii.

Start the engine and check the idling speed.


viii.

Keep your left foot pressed firmly on the brake pedal and move the shift lever to D.


ix.

Measure the line pressure when the engine is idling.


x.

Fully depress the accelerator pedal with your right foot. Quickly read the highest line pressure when the engine speed reaches the stall speed.


xi.

In the same manner, perform the test with the shift lever in R.

Specified Line Pressure
Condition D Position R Position
Stall speed 1050 to 1250 kPa
(10.7 to 12.7 kgf/cm2, 152 to 181 psi)
1400 to 1750 kPa
(14.3 to 17.8 kgf/cm2, 203 to 254 psi)

Evaluation
Problem Possible Cause
Measured values at both positions are higher than specified pressure
·

Shift solenoid valve SLT defective

·

Regulator valve defective


Measured values at both positions are below specified pressure
·

Shift solenoid valve SLT defective

·

Regulator valve defective

·

Oil pump defective

·

O/D direct clutch defective


Pressure is low in D only
·

D position circuit fluid leak

·

Forward clutch defective


Pressure is low in R only
·

R position circuit fluid leak

·

Direct clutch defective

·

1st and reverse brake defective