Home › Drivetrain › A343E AUTOMATIC TRANSMISSION / TRANSAXLE › OIL PUMP
RM1840EF _52 Drivetrain _009610 A343E AUTOMATIC TRANSMISSION / TRANSAXLE _0052476 OIL PUMP A

A343E AUTOMATIC TRANSMISSION / TRANSAXLE  OIL PUMP  REASSEMBLY  


PROCEDURE

Hide 1.INSTALL FRONT OIL PUMP OIL SEAL

AT05154
1.146,1.25 0.583,0.781 false 0.25,0.677 0.688,0.875 0.438,0.198 10 false SST

a.

Using SST and a hammer, tap in a new front oil pump oil seal.

SST
09350-30020  (09351-32140)

HINT:

Make sure the front oil pump oil seal end is flush with the outer edge of the pump body.



b.

Coat the lip of the front oil pump oil seal with MP grease.


Hide 2.FIX FRONT OIL PUMP BODY

a.

Place the front oil pump body on the torque converter assembly.


Hide 3.INSTALL FRONT OIL PUMP DRIVEN GEAR

D025800

a.

Coat the driven gear with ATF.


b.

Install the driven gear to the front oil pump body.


Hide 4.INSTALL FRONT OIL PUMP DRIVE GEAR

D025799

a.

Coat the drive gear with ATF.


b.

Install the drive gear to the front oil pump body.


Hide 5.INSTALL STATOR SHAFT ASSEMBLY

C283054

a.

Align the bolt holes of the stator shaft with the bolt holes of the front oil pump body and install the stator shaft assembly to the front oil pump body.


b.

Install the 13 bolts.

Torque:
9.8 N*m (100 kgf*cm, 87 in.*lbf)


Hide 6.INSTALL CLUTCH DRUM OIL SEAL RING

AT08409

a.

Coat 2 new clutch drum oil seal rings with ATF.


b.

Squeeze the ends of the 2 oil seal rings together with the overlap distance 8.0 mm (0.314 in.) or less, and then install them to the stator shaft groove.

HINT:

After installing the oil seal rings, check that they rotate smoothly.



Hide 8.INSTALL FRONT OIL PUMP BODY O-RING

D025646

a.

Coat a new O-ring with ATF and Install it to the front oil pump body.