Home › Drivetrain › A343E AUTOMATIC TRANSMISSION / TRANSAXLE › AUTOMATIC TRANSMISSION SYSTEM(for 2TR-FE) › 2012.04–2012.10
RM1840EF _52 Drivetrain _009610 A343E AUTOMATIC TRANSMISSION / TRANSAXLE _0052477 AUTOMATIC TRANSMISSION SYSTEM(for 2TR-FE) D

A343E AUTOMATIC TRANSMISSION / TRANSAXLE  AUTOMATIC TRANSMISSION SYSTEM(for 2TR-FE)  MANUAL SHIFTING TEST  


MANUAL SHIFTING TEST


HINT:
·

Through this test, it can be determined whether the trouble occurs in an electrical circuit or if it is a mechanical problem in the transmission.

·

If any abnormalities are found in the following test, the problem is in the transmission itself.



a.
C238306

Disconnect the connector of the transmission wire.

HINT:

It is possible to deactivate the electrical shift control by disconnecting the transmission wire. The gear positions can then be changed mechanically with the shift lever.



b.

Drive the vehicle with the transmission wire disconnected. Move the shift lever to each position to check whether the gear position changes as shown in the table below.

Shift Lever Position Gear Position
P P
R R
D 4th
3 4th
2 3rd
L 1st


c.

Connect the connector of the transmission wire.


d.