Home › Drivetrain › A343F AUTOMATIC TRANSMISSION / TRANSAXLE › AUTOMATIC TRANSMISSION SYSTEM › 2011.10–2012.10
RM1840EF _52 Drivetrain _009611 A343F AUTOMATIC TRANSMISSION / TRANSAXLE _0052478 AUTOMATIC TRANSMISSION SYSTEM D

A343F AUTOMATIC TRANSMISSION / TRANSAXLE  AUTOMATIC TRANSMISSION SYSTEM  DTC CHECK / CLEAR  


CHECK DTC


a.

DTCs which are stored in the ECM can be output to the intelligent tester.

The tester can display pending DTCs and current DTCs. Some DTCs are not stored unless a malfunction is detected in consecutive driving cycles. When a malfunction is detected in only one driving cycle, it is stored as a pending DTC.

i.

Connect the intelligent tester to the DLC3.


ii.

Turn the ignition switch to ON.


iii.

Turn the intelligent tester on.


iv.

Enter the following menus: Powertrain / Engine and ECT / DTC.

Powertrain > Engine and ECT > Trouble Codes
50001 234

v.

Confirm the DTCs and freeze frame data, and then write them down.


vi.

Confirm the details of the DTCs (See page Drivetrain>A343F AUTOMATIC TRANSMISSION / TRANSAXLE>AUTOMATIC TRANSMISSION SYSTEM>DIAGNOSTIC TROUBLE CODE CHART).

NOTICE:

When simulating a symptom with the scan tool to check for DTCs, use normal mode. For codes on the Diagnostic Trouble Code Chart subject to "2-trip detection logic", perform the following actions:

Turn the ignition switch off after the symptom is simulated once. Then repeat the simulation process. When the symptom has been simulated twice, the MIL illuminates and the DTCs are stored in the ECM.





CLEAR DTC (using intelligent tester)


a.

Connect the intelligent tester to the DLC3.


b.

Turn the ignition switch to ON.


c.

Turn the intelligent tester on.


d.

Enter the following menus: Powertrain / Engine and ECT / DTC / Clear.

Powertrain > Engine and ECT > Clear DTCs
50002 234


CLEAR DTC (without using intelligent tester)


a.

Perform either of the following operations.

i.

Disconnect the cable from the negative (-) battery terminal for more than 1 minute.


ii.

Remove the EFI and ETCS fuses from the engine room relay block and junction block assembly located inside the engine compartment for more than 1 minute.