Home › Drivetrain › A343F AUTOMATIC TRANSMISSION / TRANSAXLE › ATF TEMPERATURE SENSOR
RM1840EF _52 Drivetrain _009611 A343F AUTOMATIC TRANSMISSION / TRANSAXLE _0052481 ATF TEMPERATURE SENSOR A

A343F AUTOMATIC TRANSMISSION / TRANSAXLE  ATF TEMPERATURE SENSOR  INSTALLATION  


PROCEDURE

Hide 1.INSTALL ATF TEMPERATURE SENSOR

a.

Coat a new O-ring with ATF and install it to the ATF temperature sensor.


b.

Using a 19 mm union nut wrench, Install the ATF temperature sensor.

Torque:
29 N*m (300 kgf*cm, 22 ft.*lbf)

NOTICE:

Use the formula to calculate special torque value for situations where a union nut wrench is combined with a torque wrench (See page General>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION).



c.

Attach the ATF temperature sensor connector clamp to the wire harness bracket.


d.

Connect the ATF temperature sensor connector.