1.ADJUST PARK/NEUTRAL POSITION SWITCH ASSEMBLY
Remove the 2 bolts and heat insulator.
| *1 | Groove |
| *2 | Neutral Basic Line |
Loosen the bolt of the park/neutral position switch and move the shift lever to N.
Align the groove with the neutral basic line.
Hold the switch in position and tighten the bolt.
After the adjustment, perform the on-vehicle inspection (See page Drivetrain>A343F AUTOMATIC TRANSMISSION / TRANSAXLE>PARK / NEUTRAL POSITION SWITCH>ON-VEHICLE INSPECTION).
Install the heat insulator with the 2 bolts.