Home › Drivetrain › A343F AUTOMATIC TRANSMISSION / TRANSAXLE › PARK / NEUTRAL POSITION SWITCH
RM1840EF _52 Drivetrain _009611 A343F AUTOMATIC TRANSMISSION / TRANSAXLE _0052484 PARK / NEUTRAL POSITION SWITCH A

A343F AUTOMATIC TRANSMISSION / TRANSAXLE  PARK / NEUTRAL POSITION SWITCH  INSTALLATION  


PROCEDURE

Hide 1.INSTALL PARK/NEUTRAL POSITION SWITCH ASSEMBLY

a.

Install the park/neutral position switch to the manual valve lever shaft and temporarily install the adjusting bolt.


b.

Install a new lock washer and the nut.

Torque:
7.0 N*m (71 kgf*cm, 62 in.*lbf)


c.
C236140
1.375,0.104 1.604,0.292 0.229,0.188 10 false N 1.771,0.427 2.01,0.635 0.24,0.208 10 false R 2.292,0.323 2.448,0.5 0.156,0.177 10 false P

Turn the control shaft lever LH clockwise until it stops, and then turn it counterclockwise 2 notches to set it to the N position.


d.
C213713
1.906,1.438 0.74,1.01 0.74,1.01 0.594,1.01 true 1.927,0.677 2.125,0.24 2.125,0.24 2.271,0.24 true 0.385,0.917 0.604,1.104 0.219,0.188 10 false *1 2.323,0.135 2.542,0.323 0.219,0.188 10 false *2
*1 Groove
*2 Neutral Basic Line


Align the groove with the neutral basic line.


e.

Hold the switch in position and tighten the bolt.

Torque:
13 N*m (130 kgf*cm, 9 ft.*lbf)


f.

Using a screwdriver, bend the tabs of the lock washer.


g.

Connect the parking/neutral position switch connector.


h.

Install the heat insulator with the 2 bolts.

Torque:
7.5 N*m (76 kgf*cm, 66 in.*lbf)