1.INSPECT SHIFT LOCK CONTROL ECU
| *a | Component with harness connected
(Shift Lock Control ECU) |
Measure the voltage and resistance according to the value(s) in the table below.
Do not disconnect the shift lock control ECU connector.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| G37-6 (ACC) - G37-8 (E) | Ignition switch ON | 10 to 14 V |
| Ignition switch ACC | 10 to 14 V | |
| Ignition switch off | Below 1 V | |
| G37-7 (STP) - G37-8 (E) | Brake pedal depressed | 10 to 14 V |
| Brake pedal released | Below 1 V | |
| G37-12 (KLS+) - G37-8 (E) | 1. Ignition switch ACC and shift lever in P | Below 1 V |
| 2. Ignition switch ACC and shift lever not in P (Within approx. 1 second) | 7.5 to 11 V | |
| 3. Ignition switch ACC and shift lever not in P (After approx. 2 seconds) | 6 to 9 V | |
| G37-1 (IG) - G37-8 (E) | Ignition switch ON | 10 to 14 V |
| Ignition switch off | Below 1 V | |
| G37-8 (E) - Body ground | Always | Below 1 Ω |
If the result is not as specified, replace the transmission floor shift assembly.