1.INSPECT PARK/NEUTRAL POSITION SWITCH ASSEMBLY
| *a | Component without harness connected
(Park/Neutral Position Switch) |
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Shift Lever Position | Specified Condition |
|---|---|---|
| 4 (B) - 5 (L) | Shift lever in P or N | Below 1 Ω |
| 2 (RB) - 1 (RL) | Shift lever in R | Below 1 Ω |
| 2 (RB) - 7 (DL) | Shift lever in D or 4 | Below 1 Ω |
| 2 (RB) - 3 (2L) | Shift lever in 3 | Below 1 Ω |
| 2 (RB) - 8 (LL) | Shift lever in 2 or L | Below 1 Ω |
| 4 (B) - 5 (L) | Shift lever not in P or N | 10 kΩ or higher |
| 2 (RB) - 1 (RL) | Shift lever not in R | 10 kΩ or higher |
| 2 (RB) - 7 (DL) | Shift lever not in D or 4 | 10 kΩ or higher |
| 2 (RB) - 3 (2L) | Shift lever not in 3 | 10 kΩ or higher |
| 2 (RB) - 8 (LL) | Shift lever not in 2 or L | 10 kΩ or higher |
If the result is not as specified, replace the park/neutral position switch.