Home › Drivetrain › A750F AUTOMATIC TRANSMISSION / TRANSAXLE › SHIFT LEVER › from 2012.04
RM1840EF _52 Drivetrain _009612 A750F AUTOMATIC TRANSMISSION / TRANSAXLE _0052499 SHIFT LEVER G

A750F AUTOMATIC TRANSMISSION / TRANSAXLE  SHIFT LEVER  INSPECTION  


PROCEDURE

Hide 1.INSPECT SHIFT LOCK CONTROL ECU

C113154
1.458,0.552 1.938,0.896 0.479,0.344 1.01,1.885 0.792,0.802 true 2.396,1.885 2.719,0.802 true 1.031,2.365 0.813,3.031 true 2.104,2.375 2.104,3.042 true 2.396,2.375 2.573,3.031 true 0.583,0.583 1.042,0.813 0.458,0.229 10 false ACC 2.708,0.573 3.042,0.813 0.333,0.24 10 false IG 0.583,3.083 1.042,3.292 0.458,0.208 10 false KLS+ 2.052,3.094 2.26,3.271 0.208,0.177 10 false E 2.479,3.094 2.844,3.313 0.365,0.219 10 false STP 1.573,0.646 1.948,0.844 0.375,0.198 10 false G37 0.146,0.115 0.417,0.313 0.271,0.198 10 false *a
*a Component with harness connected
(Shift Lock Control ECU)


a.

Measure the voltage and resistance according to the value(s) in the table below.

HINT:

Do not disconnect the shift lock control ECU connector.


Standard Voltage and Resistance:
Tester Connection Condition Specified Condition
G37-6 (ACC) - G37-8 (E) Ignition switch ON 10 to 14 V
Ignition switch ACC 10 to 14 V
Ignition switch off Below 1 V
G37-7 (STP) - G37-8 (E) Brake pedal depressed 10 to 14 V
Brake pedal released Below 1 V
G37-12 (KLS+) - G37-8 (E) 1. Ignition switch ACC and shift lever in P Below 1 V
2. Ignition switch ACC and shift lever not in P (Within approx. 1 second) 7.5 to 11 V
3. Ignition switch ACC and shift lever not in P (After approx. 2 seconds) 6 to 9 V
G37-1 (IG) - G37-8 (E) Ignition switch ON 10 to 14 V
Ignition switch off Below 1 V
G37-8 (E) - Body ground Always Below 1 Ω


If the result is not as specified, replace the transmission floor shift assembly.