Home › Drivetrain › A750F AUTOMATIC TRANSMISSION / TRANSAXLE › OIL PUMP › from 2012.04
RM1840EF _52 Drivetrain _009612 A750F AUTOMATIC TRANSMISSION / TRANSAXLE _0052507 OIL PUMP A

A750F AUTOMATIC TRANSMISSION / TRANSAXLE  OIL PUMP  REASSEMBLY  


PROCEDURE

Hide 1.INSTALL FRONT OIL PUMP OIL SEAL

a.
D027961
1.813,1.25 2.302,1.25 true 2.365,1.177 2.708,1.375 0.344,0.198 10 false SST

Using SST and a hammer, tap in a new oil seal.

SST
09350-30020  (09351-32140)

HINT:

Make sure the oil seal end is flush with the outer edge of the pump body.



b.

Coat the lip of the oil seal with MP grease.


Hide 2.FIX FRONT OIL PUMP BODY SUB-ASSEMBLY

a.

Place the oil pump body on the torque converter clutch.


Hide 3.INSTALL FRONT OIL PUMP DRIVEN GEAR

a.
D027959

Coat the driven gear with ATF.


b.

Install the driven gear to the oil pump body.


Hide 4.INSTALL FRONT OIL PUMP DRIVE GEAR

a.
D027958

Coat the drive gear with ATF.


b.

Install the drive gear to the oil pump body.


Hide 5.INSTALL FRONT OIL PUMP BODY O-RING

a.
D027963
1.865,0.396 1.417,0.198 false 1.229,0.073 1.479,0.26 0.25,0.188 10 false *1
*1 New O-Ring


Coat a new O-ring with ATF and install it to the oil pump body.


Hide 6.INSTALL STATOR SHAFT ASSEMBLY

a.
D027953

Align the bolt holes of the stator shaft with the bolt holes of the oil pump body and install the stator shaft to the oil pump body.


b.

Install the 14 bolts.

Torque:
11 N*m (110 kgf*cm, 8 ft.*lbf)


Hide 7.INSTALL CLUTCH DRUM OIL SEAL RING

a.
D027952
2.094,0.229 2.396,0.427 0.302,0.198 10 false x 3

Coat 3 new oil seal rings with ATF.


b.

Squeeze the ends of the 3 oil seal rings together with an overlap distance of 8 mm (0.314 in.) or less, and then install them to the starter shaft groove.

HINT:

After installing the oil seal rings, check that they rotate smoothly.


NOTICE:

Do not excessively widen the rings.



Hide 9.INSTALL AUTOMATIC TRANSMISSION CASE O-RING

a.
D027950
0.833,0.583 0.74,0.146 0.74,0.146 0.854,0.146 false 0.917,0.063 1.177,0.25 0.26,0.188 10 false *1
*1 New O-Ring


Coat a new O-ring with ATF and install it to the oil pump assembly.