Wash off brake fluid immediately if it comes in contact with any painted surface.
If any work is performed on the clutch system or if there is thought to be air in the clutch lines, bleed air from the clutch hydraulic system.
1. FILL RESERVOIR WITH BRAKE FLUID
Remove the brake master cylinder reservoir filler cap assembly.
Add brake fluid to keep the level between the MIN and MAX lines of the reservoir while bleeding the brakes.
SAE J1703 or FMVSS No. 116 DOT3
2. BLEED AIR FROM CLUTCH LINE
Remove the bleeder plug cap of the release cylinder.
Connect a vinyl tube to the bleeder plug.
Depress the clutch pedal several times, and then loosen the bleeder plug while the pedal is depressed.
When fluid no longer comes out, tighten the bleeder plug, and then release the clutch pedal.
Repeat the previous 2 steps until all the air in the fluid is completely bled.
Tighten the bleeder plug.
Install the bleeder plug cap.
Check that all the air has been bled from the clutch line.
3. CHECK FLUID LEVEL IN RESERVOIR
Check for brake fluid leaks.
Check the brake fluid level in the reservoir (See page Brake>BRAKE SYSTEM (OTHER)>BRAKE FLUID(w/ VSC)>ON-VEHICLE INSPECTION).
Install the brake master cylinder reservoir filler cap assembly.