Home › Drivetrain › R150 / R151 / R156 MANUAL TRANSMISSION / TRANSAXLE › INPUT SHAFT › 2011.10–2012.10
RM1840EF _52 Drivetrain _009614 R150 / R151 / R156 MANUAL TRANSMISSION / TRANSAXLE _0052521 INPUT SHAFT A

R150 / R151 / R156 MANUAL TRANSMISSION / TRANSAXLE  INPUT SHAFT  REASSEMBLY  


PROCEDURE

Hide 1.INSTALL INPUT SHAFT FRONT BEARING

D029020
0.938,0.875 0.521,0.604 0.521,0.604 1.042,0.604 true 0.125,0.51 0.458,0.708 0.333,0.198 10 false SST

a.

Using SST and a press, press in a new front bearing to the input shaft.

SST
09950-60010  (09951-00570)
09950-70010  (09951-07100)

NOTICE:

Install the input shaft front bearing so that the snap ring groove is on the front side.



Hide 2.INSTALL FRONT BEARING SHAFT SNAP RING

a.

Select a snap ring so that the clearance between the input shaft and front bearing is within the specification.

Standard clearance:

0.10 mm (0.0039 in.) or less


Snap Ring Thickness:
Mark Thickness
A 2.10 to 2.15 mm (0.0827 to 0.0846 in.)
B 2.15 to 2.20 mm (0.0846 to 0.0866 in.)
C 2.20 to 2.25 mm (0.0866 to 0.0886 in.)
D 2.25 to 2.30 mm (0.0886 to 0.0906 in.)
E 2.30 to 2.35 mm (0.0906 to 0.0925 in.)
F 2.35 to 2.40 mm (0.0925 to 0.0945 in.)
G 2.40 to 2.45 mm (0.0945 to 0.0965 in.)



b.
D026115

Using a snap ring expander, install the snap ring.


Hide 3.INSTALL INPUT SHAFT BEARING

a.
D026114

Apply gear oil to the input shaft bearing, and install it to the input shaft.