Home › Drivetrain › R150 / R151 / R156 MANUAL TRANSMISSION / TRANSAXLE › COUNTER GEAR › 2011.10–2012.10
RM1840EF _52 Drivetrain _009614 R150 / R151 / R156 MANUAL TRANSMISSION / TRANSAXLE _0052524 COUNTER GEAR A

R150 / R151 / R156 MANUAL TRANSMISSION / TRANSAXLE  COUNTER GEAR  REASSEMBLY  


PROCEDURE

Hide 1.INSTALL COUNTER GEAR FRONT BEARING

a.
D026124
1.854,0.448 1.646,0.656 false 1.729,0.229 2.042,0.427 0.313,0.198 10 false SST

Using SST and a press, press in a new front bearing to the counter gear.

SST
09515-10010  

NOTICE:

Install the bearing so that the snap ring groove of the bearing faces forward.



Hide 2.INSTALL NO. 2 COUNTER GEAR FRONT BEARING SNAP RING

a.

Select a snap ring so that the clearance between the counter gear and snap ring is within the specification.

Standard clearance:

0.1 mm (0.00393 in.) or less


Snap Ring Thickness:
Mark Thickness
A 2.05 to 2.10 mm (0.0807 to 0.0827 in.)
B 2.10 to 2.15 mm (0.0827 to 0.0846 in.)
C 2.15 to 2.20 mm (0.0846 to 0.0866 in.)
D 2.20 to 2.25 mm (0.0866 to 0.0886 in.)
E 2.25 to 2.30 mm (0.0886 to 0.0906 in.)
F 2.30 to 2.35 mm (0.0906 to 0.0925 in.)



b.
D026119

Using a snap ring expander, install the snap ring.