1.INSTALL INPUT SHAFT FRONT BEARING
Using SST and a press, press in a new front bearing to the input shaft.
Install the input shaft front bearing so that the snap ring groove is on the front side.
2.INSTALL FRONT BEARING SHAFT SNAP RING
Select a snap ring so that the clearance between the input shaft and front bearing is within the specification.
0.10 mm (0.00393 in.) or less
| Mark | Thickness |
|---|---|
| A | 2.10 to 2.15 mm (0.0827 to 0.0846 in.) |
| B | 2.15 to 2.20 mm (0.0846 to 0.0866 in.) |
| C | 2.20 to 2.25 mm (0.0866 to 0.0886 in.) |
| D | 2.25 to 2.30 mm (0.0886 to 0.0906 in.) |
| E | 2.30 to 2.35 mm (0.0906 to 0.0925 in.) |
| F | 2.35 to 2.40 mm (0.0925 to 0.0945 in.) |
| G | 2.40 to 2.45 mm (0.0945 to 0.0965 in.) |
Using a snap ring expander, install the snap ring.
3.INSTALL INPUT SHAFT BEARING
Apply gear oil to the input shaft bearing, and install it to the input shaft.