1.CHECK TRANSFER INPUT SHAFT
Using a micrometer, measure the diameter of the transfer input shaft journal surface.
47.59 mm (1.8737 in.)
If the diameter is less than the minimum, replace the transfer input shaft.
Using a dial indicator, measure the inside diameter of the transfer input shaft bushing.
39.14 mm (1.5409 in.)
If the inside diameter is more than the maximum, replace the transfer input shaft.
2.CHECK FRONT TRANSFER DRIVE CLUTCH SYNCHRONIZER RING (for Manual Transmission)
While pushing in the front transfer drive clutch synchronizer ring, try to turn the ring in both directions. Check that the ring cannot be rotated.
Using a feeler gauge, measure the clearance between the front transfer drive clutch synchronizer ring and transfer input shaft spline.
1.05 to 1.85 mm (0.0414 to 0.0728 in.)
1.05 mm (0.0414 in.)
If the clearance is less than the minimum, replace the front transfer drive clutch synchronizer ring.
3.CHECK PLANETARY PINION GEAR THRUST CLEARANCE
Using a feeler gauge, measure the thrust clearance of the pinion gear.
0.11 to 0.84 mm (0.00434 to 0.0330 in.)
0.84 mm (0.0330 in.)
If the clearance is more than the maximum, replace the transfer low planetary gear assembly.
4.CHECK PLANETARY PINION GEAR RADIAL CLEARANCE
Using a dial indicator, measure the radial clearance of the pinion gear.
0.009 to 0.038 mm (0.000355 to 0.00149 in.)
0.038 mm (0.00149 in.)
If the clearance is more than the maximum, replace the transfer low planetary gear assembly.
5.CHECK TRANSFER DRIVE SPROCKET THRUST CLEARANCE
Using a feeler gauge, measure the thrust clearance.
0.10 to 0.25 mm (0.00394 to 0.00984 in.)
0.25 mm (0.00984 in.)
If the thrust clearance is more than the maximum, replace the drive sprocket.
6.CHECK REAR TRANSFER OUTPUT SHAFT
Using a micrometer, measure the diameter of the rear transfer output shaft journal surface.
27.98 mm (1.1016 in.)
36.98 mm (1.4561 in.)
If the diameter is less than the minimum, replace the output shaft.
7.CHECK TRANSFER DRIVE SPROCKET RADIAL CLEARANCE
Using a dial indicator, measure the radial clearance between the drive sprocket and output shaft with the needle roller bearing installed.
0.010 to 0.055 mm (0.000394 to 0.00216 in.)
0.055 mm (0.00216 in.)
If the radial clearance is more than the maximum, replace the transfer drive sprocket sub-assembly or needle roller bearing.
8.CHECK TRANSFER HIGH AND LOW CLUTCH SLEEVE AND NO. 2 TRANSFER GEAR SHIFT FORK CLEARANCE
Using a feeler gauge, measure the clearance between the clutch sleeve and No. 2 gear shift fork.
0.25 mm (0.00984 in.)
If the clearance is more than the maximum, replace the transfer high and low clutch sleeve or No. 2 transfer gear shift fork.
9.CHECK FRONT DRIVE CLUTCH SLEEVE AND NO. 1 TRANSFER GEAR SHIFT FORK CLEARANCE
Using a feeler gauge, measure the clearance between the clutch sleeve and No. 1 gear shift fork.
0.25 mm (0.00984 in.)
If the clearance is more than the maximum, replace the front drive clutch sleeve or No. 1 transfer gear shift fork.