1.INSPECT TRANSFER INDICATOR SWITCH (4WD POSITION AND L4 POSITION)
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Switch Condition | Specified Condition |
|---|---|---|
| 1 - 2 | Pushed | Below 1 Ω |
| 1 - 2 | Not pushed | 100 kΩ or higher |
If the resistance is not as specified, replace the transfer indicator switch.
2.INSPECT TRANSFER INDICATOR SWITCH (NEUTRAL POSITION)
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Switch Condition | Specified Condition |
|---|---|---|
| 1 - 2 | Pushed | Below 1 Ω |
| 1 - 2 | Not pushed | 100 kΩ or higher |
If the resistance is not as specified, replace the transfer indicator switch.