When using a vise, place aluminum plates between the part and vise.
When using a vise, do not overtighten it.
1.INSPECT FRONT DRIVE SHAFT
Check that there is no excessive play in the radial direction of the outboard joint.
Check that the inboard joint slides smoothly in the thrust direction.
Check that there is no excessive play in the radial direction of the inboard joint.
Check the 2 joint boots for damage.
Check that the 2 joint boots are not stretched or contracted when the front drive shaft is at the standard length.
| Item | Length |
|---|---|
| for LH Side | 540.9 mm (1.77 ft.) |
| for RH Side |
Keep the front drive shaft level during inspection.
If the joint boots are stretched or contracted, correct them.