Home › Drivetrain › DRIVE SHAFT / PROPELLER SHAFT › FRONT DRIVE SHAFT ASSEMBLY
RM1840EF _52 Drivetrain _009617 DRIVE SHAFT / PROPELLER SHAFT _0052544 FRONT DRIVE SHAFT ASSEMBLY A

DRIVE SHAFT / PROPELLER SHAFT  FRONT DRIVE SHAFT ASSEMBLY  DISASSEMBLY  


CAUTION / NOTICE / HINT

NOTICE:
·

When using a vise, place aluminum plates between the part and vise.

·

When using a vise, do not overtighten it.



HINT:
·

Use the same procedure for the RH and LH sides.

·

The procedure listed below is for the LH side.



PROCEDURE

Hide 1.REMOVE FRONT AXLE INBOARD JOINT BOOT CLAMP

C111183

a.

Using pliers, detach the claw and remove the large clamp.


b.
C237741

Using pliers, remove the small boot clamp.


Hide 2.DISCONNECT INBOARD JOINT BOOT

a.

Disconnect the inboard joint boot from the inboard joint.


Hide 3.REMOVE INBOARD JOINT

FA01615
1.594,0.792 0.948,0.792 false 1.854,0.438 0.802,0.438 true 1.49,1.052 0.948,1.052 0.948,1.052 0.948,0.448 false 0.583,0.333 0.74,0.49 0.156,0.156 10 false *1
*1 Matchmark


a.

Remove any old grease from the inboard joint.


b.

Place matchmarks on the tripod, and the inboard and outboard joints.

NOTICE:

Do not use a punch to make the matchmarks.



c.

Remove the inboard joint from the outboard joint.


d.
G022501

Using a snap ring expander, remove the snap ring.


e.
C127649
2.677,0.76 2.677,1.542 2.677,1.542 2.938,1.542 true 2.802,0.844 2.802,1.531 true 3,1.438 3.313,1.635 0.313,0.198 10 false *1
*1 Matchmark


Place matchmarks on the outboard joint and tripod.

NOTICE:

Do not use a punch to make the matchmarks.



f.

Using a brass bar and hammer, tap off the tripod from the outboard joint.

NOTICE:

Do not tap the rollers.



g.

Remove the joint boot.


Hide 4.REMOVE FRONT AXLE OUTBOARD JOINT BOOT CLAMP

a.
C081566

Using pliers, remove the boot clamps as shown in the illustration.


Hide 5.REMOVE OUTBOARD JOINT BOOT

a.

Remove the outboard joint boot from the outboard joint shaft.


b.

Remove any old grease from the outboard joint shaft.


Hide 6.REMOVE FRONT DRIVE SHAFT DUST COVER

F040647
2.042,0.854 2.042,0.573 2.042,0.573 2.198,0.573 false 2.26,0.479 2.563,0.635 0.302,0.156 10 false SST

a.

Using SST and a press, press out the dust cover.

SST
09950-00020  


Hide 7.REMOVE FRONT AXLE HUB DUST SEAL

C034791

a.

Using a screwdriver and hammer, remove the dust seal.