1.REMOVE PROPELLER SHAFT WITH CENTER BEARING ASSEMBLY (for 2WD and Pre-Runner)
| *1 | Matchmark |
Place matchmarks on the propeller shaft flange and differential flange.
Remove the 4 nuts, 4 bolts and 4 washers and disconnect the propeller shaft.
Remove the 2 bolts from the frame crossmember.
Pull out the propeller shaft.
Install SST to the extension housing to prevent oil leakage.
2.REMOVE PROPELLER SHAFT WITH CENTER BEARING ASSEMBLY (for 4WD)
| *1 | Matchmark |
Place matchmarks on the propeller shaft flange and transfer flange.
Remove the 4 nuts and 4 washers and disconnect the propeller shaft.
| *1 | Matchmark |
Place matchmarks on the propeller shaft flange and differential flange.
Remove the 4 nuts, 4 bolts and 4 washers.
Remove the 2 bolts from the frame crossmember.
Remove the propeller shaft.