Home › Drivetrain › DRIVE SHAFT / PROPELLER SHAFT › FRONT PROPELLER SHAFT ASSEMBLY(for TASA Made)
RM1840EF _52 Drivetrain _009617 DRIVE SHAFT / PROPELLER SHAFT _0052548 FRONT PROPELLER SHAFT ASSEMBLY(for TASA Made) G

DRIVE SHAFT / PROPELLER SHAFT  FRONT PROPELLER SHAFT ASSEMBLY(for TASA Made)  INSPECTION  


PROCEDURE

Hide 1.INSPECT FRONT PROPELLER SHAFT ASSEMBLY

F052087

a.

Using a dial indicator, measure the propeller shaft runout.

Maximum runout:

0.8 mm (0.0314 in.)


If the runout is more than the maximum, replace the propeller shaft.


Hide 2.INSPECT UNIVERSAL JOINT SPIDER ASSEMBLY

a.

Clamp the propeller shaft in a vise between aluminum plates.

NOTICE:

Do not overtighten the vise.



b.

Check the spider bearings for wear or damage.


c.
C172298

Check the axial play of each spider bearing by turning the yoke while holding the shaft tightly.

Maximum bearing axial play:

0.05 mm (0.00196 in.)


If the axial play is more than the maximum, replace the spider bearing.