Home › Drivetrain › DRIVE SHAFT / PROPELLER SHAFT › PROPELLER SHAFT ASSEMBLY(for TASA Made)
RM1840EF _52 Drivetrain _009617 DRIVE SHAFT / PROPELLER SHAFT _0052549 PROPELLER SHAFT ASSEMBLY(for TASA Made) G

DRIVE SHAFT / PROPELLER SHAFT  PROPELLER SHAFT ASSEMBLY(for TASA Made)  INSPECTION  


PROCEDURE

Hide 1.INSPECT PROPELLER SHAFT AND INTERMEDIATE SHAFT

C061260

a.

Using a dial indicator, measure the propeller shaft and intermediate shaft runout.

Maximum Runout:
Item Specified Condition
Propeller shaft 0.8 mm (0.0314 in.)
Intermediate shaft 0.8 mm (0.0314 in.)


If the shaft runout is more than the maximum, replace the shaft.


Hide 2.INSPECT UNIVERSAL JOINT SPIDER ASSEMBLY

a.

Clamp the propeller shaft in a vise between aluminum plates.

NOTICE:

Do not overtighten the vise.



b.

Check the spider bearings for wear or damage.


c.
C172298

Check the axial play of each spider bearing by turning the yoke while holding the shaft tightly.

Maximum bearing axial play:

0.05 mm (0.00196 in.)


If the bearing axial play is more than the maximum, replace the spider bearing.


Hide 3.INSPECT CENTER NO. 1 SUPPORT BEARING ASSEMBLY

C118618

a.

While turning the center bearing by hand, check that it turns smoothly without catching and that there are no cracks or damage.

If there are any defects, replace the bearing.

If there is any damage to the lip of the center bearing case, replace the bearing.