Use the same procedure for the RH and LH sides.
The procedure listed below is for the LH side.
1.REMOVE FRONT WHEEL
2.REMOVE FRONT DISC BRAKE CYLINDER ASSEMBLY LH
Remove the bolt and brake tube bracket from the steering knuckle.
Remove the 2 bolts and disc brake cylinder.
Use wire or an equivalent tool to keep the brake cylinder from hanging down by the front flexible hose.
3.REMOVE FRONT DISC
4.REMOVE FRONT AXLE HUB BOLT
| *1 | Nut |
| *a | Turn |
| *b | Hold |
Temporarily install 2 nuts and 2 washers to the front axle hub bolt as shown in the illustration.
Using SST and a screwdriver, remove the hub bolt.
5.INSTALL FRONT AXLE HUB BOLT
| *1 | Washer |
| *2 | Nut |
| *a | Turn |
| *b | Hold |
Temporarily install a plate washer and nut to a new hub bolt as shown in the illustration.
Using a screwdriver to hold the front axle, install a new hub bolt by tightening the nut. Then remove the nut and plate washer.
Remove the 2 nuts from the hub bolts.
6.INSTALL FRONT DISC
7.INSTALL FRONT DISC BRAKE CYLINDER ASSEMBLY LH
Install the disc brake cylinder with the 2 bolts.
Install the brake tube bracket to the steering knuckle with the bolt.
8.INSTALL FRONT WHEEL