Home › Drivetrain › AXLE AND DIFFERENTIAL › FRONT AXLE HUB(for 4WD and Pre-Runner)
RM1840EF _52 Drivetrain _009618 AXLE AND DIFFERENTIAL _0052556 FRONT AXLE HUB(for 4WD and Pre-Runner) G

AXLE AND DIFFERENTIAL  FRONT AXLE HUB(for 4WD and Pre-Runner)  ON-VEHICLE INSPECTION  


CAUTION / NOTICE / HINT

HINT:
·

Use the same procedure for the RH and LH sides.

·

The procedure listed below is for the LH side.



PROCEDURE

Hide 1.REMOVE FRONT WHEEL

Hide 2.DISCONNECT FRONT DISC BRAKE CYLINDER ASSEMBLY LH

a.
F042731

Remove the bolt and disconnect the brake tube bracket from the steering knuckle.


b.
F050211

Remove the 2 bolts and disconnect the front disc brake caliper from the steering knuckle.

NOTICE:

Use wire or an equivalent tool to keep the brake caliper from hanging down by the front flexible hose.



Hide 4.INSPECT FRONT AXLE HUB BEARING LOOSENESS

a.
F042746

Using a dial indicator, check for looseness near the center of the front axle hub.

Maximum:

0.05 mm (0.00197 in.)


NOTICE:

Make sure that the dial indicator is set perpendicular to the measurement surface.


If the looseness is more than the maximum, replace the front axle hub sub-assembly.


Hide 5.INSPECT FRONT AXLE HUB RUNOUT

a.
F042745

Using a dial indicator, check for runout on the surface of the front axle hub inside the front axle hub bolt.

Maximum:

0.05 mm (0.00197 in.)


NOTICE:

Make sure that the dial indicator is set perpendicular to the measurement surface.


If the runout is more than the maximum, replace the front axle hub sub-assembly.


Hide 7.CONNECT FRONT DISC BRAKE CYLINDER ASSEMBLY LH

a.
F050211

Connect the front disc brake cylinder to the steering knuckle with the 2 bolts.

Torque:
122 N*m (1244 kgf*cm, 90 ft.*lbf)


b.
F042731

Install the brake tube bracket to the steering knuckle with the bolt.

Torque:
29 N*m (296 kgf*cm, 21 ft.*lbf)


Hide 8.INSTALL FRONT WHEEL

Torque:
105 N*m (1071 kgf*cm, 77 ft.*lbf)