Home › Drivetrain › AXLE AND DIFFERENTIAL › AUTOMATIC DISCONNECTING DIFFERENTIAL ACTUATOR
RM1840EF _52 Drivetrain _009618 AXLE AND DIFFERENTIAL _0052566 AUTOMATIC DISCONNECTING DIFFERENTIAL ACTUATOR G

AXLE AND DIFFERENTIAL  AUTOMATIC DISCONNECTING DIFFERENTIAL ACTUATOR  INSPECTION  


PROCEDURE

Hide 1.INSPECT DIFFERENTIAL VACUUM ACTUATOR ASSEMBLY

a.
C237690
2.313,3 3.073,3 false 2.51,3.135 2.76,3.135 2.76,3.135 2.76,3 false 2.052,3.573 1.427,3.573 false 2.448,3.531 2.844,3.531 false 3.104,2.906 3.26,3.063 0.156,0.156 10 false *1 1.24,3.479 1.396,3.635 0.156,0.156 10 false *a 2.865,3.438 3.021,3.594 0.156,0.156 10 false *b 2.031,4.156 2.479,4.323 0.448,0.167 10 false 12 mm
*1 Shift Fork
*a 2WD Side
*b 4WD Side


Measure the resistance between terminals 1 and 2.

Standard:

0.1 to 100 Ω



b.

Measure the resistance between terminal 1 or 2 and body ground.

Standard:

5 MΩ or more


If the result is not as specified, replace the differential vacuum actuator.


c.

Check the actuator using one of the following methods.

i.

Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Tester Connection Measurement Condition Specified Condition
3 - 4 Battery positive (+) → Terminal 1
Battery negative (-) → Terminal 2
Below 1 Ω
3 - 4 Battery positive (+) → Terminal 2
Battery negative (-) → Terminal 1
10 kΩ or higher
4 - 5 Battery positive (+) → Terminal 1
Battery negative (-) → Terminal 2
Below 1 Ω
4 - 5 Battery positive (+) → Terminal 2
Battery negative (-) → Terminal 1
10 kΩ or higher
4 - 6 Battery positive (+) → Terminal 1
Battery negative (-) → Terminal 2
Below 1 Ω
4 - 6 Battery positive (+) → Terminal 2
Battery negative (-) → Terminal 1
10 kΩ or higher


If the result is not as specified, replace the actuator.


ii.

Check the actuator status.

OK:
Measurement Condition Specified Condition
Battery positive (+) → Terminal 1
Battery negative (-) → Terminal 2
2WD → 4WD
Battery positive (+) → Terminal 2
Battery negative (-) → Terminal 1
4WD → 2WD


If the result is not as specified, replace the actuator.