Use the same procedure for the RH and LH sides.
The procedure listed below is for the LH side.
1.INSTALL REAR AXLE SHAFT OIL SEAL LH
Using SST and a hammer, tap in a new oil seal.
2.INSTALL O-RING
Install a new O-ring to the axle housing.
3.INSTALL REAR AXLE SHAFT WITH BACKING PLATE
Install the axle shaft with backing plate with the 4 nuts.
4.CONNECT PARKING BRAKE CABLE
Connect the parking brake cable with the 2 bolts.
5.INSTALL REAR SPEED SENSOR LH (w/ ABS)
6.INSTALL REAR BRAKE
for 2WD:
(See page Brake>BRAKE (REAR)>REAR BRAKE(for 2WD)>INSTALLATION)
for 4WD and Pre-Runner:
(See page Brake>BRAKE (REAR)>REAR BRAKE(for 4WD and Pre-Runner)>INSTALLATION)
7.INSTALL REAR WHEEL
8.ADJUST PARKING BRAKE
9.CHECK SPEED SENSOR SIGNAL