1.INSTALL DIFFERENTIAL LOCK SHIFT ACTUATOR
| *1 | Shift Fork |
| *2 | Actuator Installation Hole |
|
Outside |
Install a new O-ring to the actuator.
Install the actuator with the bolt and nut.
Check that the outermost rack tooth of the shift fork is almost directly above the center line of the actuator installation hole.
| *a | Matchmark |
| *b | 5° |
| *c | 108° |
| *d | 1.5 V |
Check that the matchmarks on the pinion of the actuator are in the range between 2 and 8° clockwise of the center line of the actuator.
If the matchmarks are not within the specified range, use dry cell batteries to rotate the pinion until the matchmarks are within the range.
Do not apply positive (+) battery voltage directly between terminals.
If the matchmarks come to the limit of the rotation range, do not apply any more voltage.
Install a new O-ring to the actuator.
Apply a light coat of gear oil to the O-ring.
Apply MP grease to the gear parts.
| *1 | Knock Pin |
Check that the outermost rack tooth of the shift fork aligns with the matchmarks on the pinion of the actuator.
Install the actuator so that the long hole in the actuator fits with the knock pin on the carrier.
Do not damage the O-ring of the actuator.
Rotate the actuator counterclockwise so that the knock pin slides to the end of the hole as shown in the illustration.
Install the bolts.
Connect the breather hose.
Connect the connector.
2.INSTALL DIFFERENTIAL BREATHER BRACKET
Install the differential breather bracket.
3.INSTALL REAR DIFFERENTIAL LOCK ACTUATOR PROTECTOR
Install the rear differential lock actuator protector with the 2 bolts and nut.