1.DISPOSE OF FRONT SHOCK ABSORBER ASSEMBLY LH
Use the same procedure for the other front shock absorber.
Fully extend the shock absorber piston rod and fix the shock absorber in place at an angle in a vise or similar tool.
| *a | Approximately 45 mm |
for 4WD, for Pre-Runner (except TMT and TASA Made):
Using a drill or similar tool, slowly make a hole approximately 45 mm (1.77 in.) from the top end of the shock absorber and discharge the gas inside of it.
The gas is colorless, odorless and harmless.
Since the discharged gas may cause chips to fly off, cover the drill with a cloth when making a hole.
| *a | Approximately 45 mm |
for Pre-Runner (TMT and TASA Made):
Using a drill or similar tool, slowly make a hole approximately 45 mm (1.77 in.) from the top end of the shock absorber and discharge the gas inside of it.
The gas is colorless, odorless and harmless.
Since the discharged gas may cause chips to fly off, cover the drill with a cloth when making a hole.