Use the same procedure for the RH and LH sides.
The procedure listed below is for the LH side.
1.REMOVE FRONT WHEEL
2.DISCONNECT FRONT STABILIZER LINK ASSEMBLY LH
Remove the nut and disconnect the stabilizer link from the steering knuckle.
If the ball joint turns together with the nut, use a 6 mm hexagon wrench to hold the stud in place.
3.DISCONNECT FRONT STABILIZER LINK ASSEMBLY RH
Use the same procedure described for the LH side.
4.REMOVE FRONT STABILIZER BRACKET
5.REMOVE FRONT STABILIZER BAR
6.REMOVE FRONT SHOCK ABSORBER WITH COIL SPRING
Remove the nut and bolt.
While fixing the nut in place, loosen and remove the bolt.
Remove the 3 nuts and shock absorber with coil spring.
7.REMOVE FRONT SUPPORT TO FRONT SHOCK ABSORBER NUT
Secure SST in a vise.
| *a | Correct |
| *b | Incorrect |
Attach the arm of SST to the diameter of the coil spring.
Make sure that the coil spring is installed so that the distance between the upper and lower hooks of SST is at the maximum.
Make sure that the claws of the hooks are securely attached.
Using SST, compress the coil spring.
If the coil spring bends during the compression, immediately stop the compression and reinstall SST.
Do not compress the spring until the coil springs contact each other.
Do not use an impact wrench.
Hold the shock absorber rod and remove the nut.
Do not remove the front support to front shock absorber nut when the coil spring is not free.
8.REMOVE FRONT SHOCK ABSORBER CUSHION RETAINER
Remove the cushion retainer from the shock absorber.
9.REMOVE FRONT SHOCK ABSORBER CUSHION
Remove the cushion from the shock absorber.
10.REMOVE FRONT SUSPENSION SUPPORT SUB-ASSEMBLY
Remove the suspension support from the coil spring.
Remove the cushion retainer from the shock absorber.
11.REMOVE FRONT COIL SPRING LH
Remove the coil spring from the shock absorber.